Incra TS-LS Table Saw Fence Instrukcja Użytkownika

INCRAThe only table saw fence with patented Automatic Lead Screw Positioning ControlTMSafety . . . . . . . . . . . . . . . . . . . . 2Fasteners and H

Calibration – Left side of saw blade Moving your TS-LS to the left side of the blade can be quite useful, especially on table saws which have a blad

If you wish to add a 3/4” thick table board between the right hand extension wing of the table saw and the TS-LS base mount assembly, begin by making

AUXILIARY FENCE MOUNTINGFor some cutting operations, you may wish to add a wooden auxiliary fence to the front face of your TS-LS fence. A T-slot i

6 each 3⁄8 – 16 x 11⁄2”hex bolt6 each 3⁄8” flat washer6 each 3⁄8” lock washer6 each 3/8 – 16 hex nut2 each 3⁄8 – 24 x 1” hex bolt (Delta Unisaw)4 each

6 each3⁄8 – 16 x 3⁄4”hex bolt6 each1⁄4 – 20 square nut10 each3⁄8 – 16rectangular nut8 each#10 – 32 x 7⁄16” Phillips flat head screw8 each#10 – 32 hex

4 INCRA Woodworking Tools & Precision Rules Unplug your table saw and remove the existing fence, including the front and rear support rails, mo

The rail positions described above will provide support for the base of the TS-LS for work on either the left or right side of the blade. Left hand r

Attach the INCRA LS Positioner Base to base support panel and loosely attach remaining base clampOpen the LS Mounting Hardware Pack B-04. Place #10 w

Set final base assembly positionLoosen the (4) base clamping knobs and slide the base assembly to locate the near side of the base support panel at 37

Important: If you have not already done so, read the Operations section of your INCRA LS Positioner manual to familiarize yourself with the clamping

FINAL CALIBRATIONImportant: As with any table saw fence, accurate calibration and alignment require that the saw blade be aligned parallel to the m